![]() ![]() ![]() To do so, exit Diskpart and then run the following commands on the command line:īcdedit /set device partition=c: If the first hard disk (Disk 0) has been swapped, you will need to rewrite the Windows boot loader. For example, if it is M0, enter the following commands:ĭiskPart successfully deleted the missing disk. Volume 0 System Rese NTFS Mirror 350 MB Healthy System - * Volume 1 C NTFS Mirror 39 GB Rebuild Bootĭelete the defective hard disk from the configuration. You can check the current status with list volume. Depending on the number and size of the files, this can take up to several hours. Select the relevant volumes one after the other and add the new hard disk to them using add disk.įor example, to add disk 1 to volumes 0 and 1, enter the following commands:ĭiskPart succeeded in adding a mirror to the volume. You can change this with the following steps. You can also see from the type simple that it is no longer a RAID volume. Volume 1 C NTFS Simple 39 GB Healthy Boot Volume 0 System Rese NTFS Simple 350 MB Healthy System You can still check the result with list volume. Select them one after the other and remove the exchanged disk with the command break.įor example, if M0 is the replaced disk and volumes 0 and 1 have the status Failed, enter the following commands in this order:ĭiskPart successfully broke the mirror volume. Pay attention to volumes that have the status failed. Volume 1 C NTFS Mirror 39 GB Failed Rd Boot Volume 0 System Rese NTFS Mirror 350 MB Failed Rd System Volume # Ltr Label Fs Type Size Status Info You can set custom rules that allow you to group more drives in one storage pool, and then create virtual drives. #Softraid windows 10 windows 10Type the list volume command to display an overview of the volumes. This built-in tool found in Windows 10 and Windows 11 protects the entire range of data stored on your hard drive, and it can customize the way the storage is used. In case of disk 1, the command would be:ĭISKPART> select disk 1 Disk 1 is now the selected disk.Įnter the convert dynamic command to convert the disk to a dynamic disk:ĭiskPart successfully converted the selected disk to dynamic format. Set the focus on the new hard disk using the command select disk. #Softraid windows 10 how toIn the following steps of this manual we will show you how to convert the new hard disk into a dynamic disk, remove the old disk from the configuration and rebuild the RAID. M0 on the other hand is the defective (and already replaced) hard disk. NAS HDDs using SMR technology might have reduced write performance after 10 minutes of work. In this example, Disk 1 is the new hard disk (easily identified by the missing * in the Dyn column). This is a free app available for both macOS and Windows. In the Console, type diskpart and then list disk to display an overview of the hard drives.Ĭopyright (C) 1999-2013 Microsoft Corporation.ĭisk 0 Online 40 GB 0 B * - Disk 1 Online 40 GB 40 GB Start the Windows Rescue System on your server. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |